ZyXEL p-662h-61 Guia Do Utilizador

Prestige 662HW Series User’s Guide

Chapter 3 Wizard Setup for Internet Access

62

Figure 7   Internet Access Wizard Setup: First Screen

The following table describes the fields in this screen.

Similar to the way houses on a street share a common street name, so too do computers on a 
LAN share one common network number.

Where you obtain your network number depends on your particular situation. If the ISP or 
your network administrator assigns you a block of registered IP addresses, follow their 
instructions in selecting the IP addresses and the subnet mask.

Table 4   Internet Access Wizard Setup: First Screen

Mode

From the Mode drop-down list box, select Routing (default) if your ISP allows 
multiple computers to share an Internet account. Otherwise select Bridge. 

Encapsulation

Select the encapsulation type your ISP uses from the Encapsulation drop-down list 
box. Choices vary depending on what you select in the Mode field.  

If you select Bridge in the Mode field, select either PPPoA or RFC 1483. 

If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or 
PPPoE.

Multiplex

Select the multiplexing method used by your ISP from the Multiplex drop-down list 
box either VC-based or LLC-based. 

Virtual Circuit 
ID

VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit. 
Refer to the appendix for more information.

VPI

Enter the VPI assigned to you. This field may already be configured.

VCI

Enter the VCI assigned to you. This field may already be configured.

Next

Click this button to go to the next wizard screen. The next wizard screen you see 
depends on what protocol you chose above. Click on the protocol link to see the next 
wizard screen for that protocol.