ZyXEL g-2000 plusv2 Guia Do Utilizador

ZyXEL G-2000 Plus v2 User’s Guide

356

Chapter 35 Remote Management

Figure 203   Menu 24.11 – Remote Management Control

The following table describes the fields in this screen. 

You can configure your ZyXEL device for remote Telnet access as shown next.

                     Menu 24.11 - Remote Management Control

     TELNET Server:     Port = 23         Access = LAN only
                        Secure Client IP = 0.0.0.0

     FTP Server:        Port = 21         Access = LAN only
                        Secure Client IP = 0.0.0.0

     Web Server:        Port = 80         Access = LAN only
                        Secure Client IP = 0.0.0.0

     SNMP Service:      Port = 161        Access = LAN only
                        Secure Client IP = 0.0.0.0

     DNS Service:       Port = 53         Access = LAN only
                        Secure Client IP = 0.0.0.0

                    Press ENTER to Confirm or ESC to Cancel:

Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service

Each of these read-only labels denotes a service or protocol.

Port

This field shows the port number for the service or protocol. You may change the 

port number if needed, but you must use the same port number to access the 

ZyXEL device.

Access

Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to 

choose from: LAN only, WAN only, ALL or Disable.

Secure Client IP

The default 0.0.0.0 allows any client to use this service or protocol to access the 

ZyXEL device. Enter an IP address to restrict access to a client with a matching IP 

address.

Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to 

Cancel" to save your configuration, or press [ESC] to cancel.