Crown ma-1202 Manual Do Utilizador
![Crown](https://files.manualsbrain.com/attachments/ad4fe37c83f8103796e2b688ca2207c0170833e9/common/fit/150/50/97448ffa3cf06c68e6fd163c5c4d945f12d2d93e0dfe71a4b3b4076cec46/brand_logo.gif)
page 9
MA Series Power Amplifiers
Operation Manual
3.6.3 Parallel-Mono Mode
See Figure 3.8. Set the back panel
stereo/mono switch to Parallel-Mono.
stereo/mono switch to Parallel-Mono.
INPUTS: Connect input wiring to Channel 1
only.
only.
OUTPUTS: Add a 14 gauge (or larger) jumper
between the red(+) Channel 1 and Channel 2
binding posts. Connect the speaker positive (+)
lead to the Channel 1 red (+) terminal. Connect
the speaker negative (-) lead to the Channel 1
black (-) terminal.
between the red(+) Channel 1 and Channel 2
binding posts. Connect the speaker positive (+)
lead to the Channel 1 red (+) terminal. Connect
the speaker negative (-) lead to the Channel 1
black (-) terminal.
Crown provides a reference of wiring pin assign-
ments for commonly used connector types in the
Crown Amplifier Application Guide.
ments for commonly used connector types in the
Crown Amplifier Application Guide.
NOTE: Use only the Channel 1 level
control.
control.
CAUTION: Parallel-Mono wiring requires
installation of a jumper wire. Do not
switch to Stereo or Bridge-Mono mode
until this output jumper wire is removed.
installation of a jumper wire. Do not
switch to Stereo or Bridge-Mono mode
until this output jumper wire is removed.
NOTE: The Channel 2 IOC indicator will
remain lit when operating in
Parallel-Mono mode.
remain lit when operating in
Parallel-Mono mode.
Figure 3.8
Parallel-Mono
Wiring
Parallel-Mono
Wiring
3 Setup