Jet 756151 wh-45t - 45" english wheel Guia Do Utilizador
15
Spindle Assembly Installation
Referring to Figure 14:
The spindle assembly (B) is mounted to the
arbor (H) and secured with a draw bar (O) and
spindle nut (D). Use the following procedure to
install the spindle assembly. Reverse the order to
remove the spindle.
arbor (H) and secured with a draw bar (O) and
spindle nut (D). Use the following procedure to
install the spindle assembly. Reverse the order to
remove the spindle.
When changing tools, making
adjustments, or doing clean-up and maint-
enance, always turn the machine off and
unplug the machine from its power source.
enance, always turn the machine off and
unplug the machine from its power source.
1. Raise the arbor (H) all the way using the
handwheel located on the front of the cabinet.
Loosen two lock knobs (E) and slide fence (J)
to rear. Remove cutter guard (K). Loosen two
lock knobs (F) and slide guard cover (G)
back.
Loosen two lock knobs (E) and slide fence (J)
to rear. Remove cutter guard (K). Loosen two
lock knobs (F) and slide guard cover (G)
back.
Locking the Arbor
2. Locate the spindle lock (L) which is
accessible through the door on the right side
of the cabinet. Pull out and rotate 90º right or
left, resetting the knob into the indent.
of the cabinet. Pull out and rotate 90º right or
left, resetting the knob into the indent.
Turn the arbor (H) by hand until it locks, then
verify that it will not rotate.
verify that it will not rotate.
Installing the Spindle Assembly
3. Thread
the
spindle nut (D) onto the threaded
end of the spindle (C) in the direction
indicated by arrows (A
indicated by arrows (A
1
, A
2
). Tighten securely
by hand.
4. Thread
the
spindle assembly (B) and nut (D)
onto the arbor (H) and hand-tighten only.
5. Insert
the
draw bar (O) through the opening in
the shaft (N) just below the drive belt (M).
Turn clockwise, fastening and securing it to
the spindle. Tighten the draw bar (O) with
spindle wrench (Inset A).
Turn clockwise, fastening and securing it to
the spindle. Tighten the draw bar (O) with
spindle wrench (Inset A).
6. Tighten the nut
(D) with the spindle
wrench provided (Inset A).
Shaper Cutter installation is described on the
following page. Note that at this time the arbor
is still locked.
following page. Note that at this time the arbor
is still locked.
Spindle Assembly Removal
Referring to Figure 14:
The arbor must be locked as described in Spindle
Attachment Installation, step 2.
Attachment Installation, step 2.
1. Remove the draw bar (O).
Figure 14