Milan e-tbt-hb-0802 Manual Do Utilizador

NOTE: Slide-in Cards can be hot-swapped.

To install a Slide-In Card:

1. Determine if the Slide-In Cards has an SQE switch and, if so,

verify that the SQE switch is in the OFF position:

NOTE: SQE switches must be set to the following OFF
positions:

•

UTP/STP card

TOWARD 20-pin edge connector

•

Thinnet card

TOWARD 20-pin edge connector

•

AUI-DCE

AWAY FROM 20-pin edge connector

•

AUI-DTE card

Not Applicable

•

Fiber Optic card

TOWARD 20-pin edge connector

•

Redundant Fiber Optic

SQE jumper setting on board should be 
labeled; if not, holding card with 20-pin edge 
connector at top, jumper two leftmost pins.

•

Bridge

Not Applicable

2. With the Slide-In Card components facing up, carefully guide

the Slide-In Card along the card guides until the Slide-In Card
connector meets the the LANMaster T8 backplane.

3. Firmly push the card into the slot until the Slide-In Card

faceplate is flat against the LANMaster T8 frame.

4. Rotate the Slide-In Card thumbscrews into the LANMaster T8

threaded holes. 

10 

9 

To connect 10BaseT Cable to RJ-45 connectors at the LANMaster T8
front:

1. Locate or build 10BaseT cables with the following

characteristics:
•

802.3 compliant (See page 18)

•

straight through cable configuration  (See page 6)

•

male RJ-45 plug connectors installed at both ends of cable.

2. Connect male RJ-45 plug connector at one end of 10BaseT

cable to LANMaster T8 RJ-45 jack connector.

3. Connect male RJ-45 plug connector at other end of 10BaseT

cable to DTE terminal RJ-45 jack connectors.

4. IF CONNECTING TWO LANMaster T8s:

•

Connect LANMaster T8s AT PORT 8, using steps 1-3.

•

Set the interface switch on one LANMaster T8 to: MDI and

the interface switch on the other LANMaster T8 to: MDI-X.

Port 8

Setting

MDI-X

MDI