PRIMERA bravo Manual Do Utilizador
22 Creating Discs
Select the Change button to install a fresh, new ink cartridge or
to switch back and forth between previously used cartridges.
After the cartridge has been replaced according to the
instructions in Section 2-C, select either the New Cartridge
Installed button or the Old Cartridge Installed button
accordingly. These selections are necessary for the printer to
accurately keep track of ink cartridge ink levels.
Disc Output Location
This can be set either Normal (Left Bind acts as output), or
Kiosk (finished discs deposited out the Front Exit). The default
is Normal (Left Bin). Note that this will only have an effect
when doing printing only − this will have no affect when
recording and printing through PrimoDVD. In PrimoDVD,
click Robotics then Options and select Kiosk Mode check box.
Enable Bi-di Printing
When enabled the Bravo will print bi-directional for faster
printing. The default is uni-directional printing. When you
enable bi-directional printing, you should perform the
Alignment Calibration described later in this section. Please
note that the calibration is stored on your computer, so if you
move to a new computer you must repeat the calibration.
Alignment Calibration
The Alignment Calibration allows you you create a test print
that will provide you with values to configure your printer for
Bi-Di- Printing and to align the color and black cartridges for
Color+Black printing. If Bi-Di Printing is enabled, or if you use
Color+Black as a
cartridge type
in the driver settings, it is
important to perform this calibration every time you change a
cartridge. To print, click the Alignment Calibration Properties
button then click Yes.. The print will look like this:
0
2
4
6
8
10
12
14
0
2
4
6
8
10
12
14
0
2
4
6
8
10
12
14
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
A
B
C
D
510141.qxd 10/3/03 1:38 PM Page 22
TOC
INDEX