Transcend 520 - 1gb Manual Do Utilizador

 

30

If an error occurs, with your T.sonic™ 520, please first check the information listed below before 

taking your T.sonic™ 520 for repair. If you are unable to remedy a problem from the following hints, 

please consult your dealer, service center, or local Transcend branch office. We also have a FAQ 

and Support on our websites. 

Enter Device Manager in the Control Panel and enable the Auto-Insert function of the CD-ROM 

drive. Alternatively, you can manually execute the T.sonic.EXE from the driver CD. 

Operating system cannot detect the T.sonic™ 520 

Check the following: 

1. Is 

your 

T.sonic™ 520 properly connected to the USB port? If not, unplug it and plug it in again. 

2. Is your T.sonic™ 520 connected to the Mac keyboard? If yes, unplug it and plug it into an 

available USB port on your Mac Desktop instead. 

3.  Is the USB port enabled? If not, refer to the user’s manual of your computer (or motherboard) to 

enable it. 

4.  Is the necessary driver installed? If your computer is using Windows

®

 98SE, you must insert the 

Driver CD into the CD-ROM and refer to the “Driver Installation for Windows

®

 98SE” section 

to complete the driver installation before using your T.sonic™ 520. A driver is not required for 

Win

®

 ME/2000/XP, Mac

™ OS 10.0 or later, or Linux™ Kernel 2.4 or later 

Check the following: 

1. Is 

the 

T.sonic™ 520 connected to your computer? If yes, unplug it. 

2. Is 

the 

LOCK switch set to “LOCK”? If yes, set it to the “OFF” position. 

3.  Is the battery inserted correctly?    If not, reverse the battery. 

4.  Is the battery out of power? If yes, please replace it with a new battery. 

As required, uninstall the driver and re-install it. If this doesn’t work, see the Recover Your T.sonic

™ 520 Chapter to recover your T.sonic™ 520.