Fortinet FORTIWIFI-50B Instrução De Instalação

Configuring NAT mode involves defining interface addresses and default routes, 
and simple firewall policies. You can use the web-based manager or the CLI to 
configure the FortiWiFi unit in NAT/Route mode.

After connecting to the web-based manager, you can use the following procedures 
to complete the basic configuration of the FortiWiFi unit. Ensure you read the 
section 

 before beginning.

When shipped, the FortiWiFi unit has a default address of 192.168.1.99 and a 
netmask of 255.255.255.0. for either the Port 1 or Internal interface. You need to 
configure this and other ports for use on your network.

Go to System > Network > Interface.

Select the edit icon for an interface.

Set the Addressing Mode for the interface.
• For Manual addressing, enter the IP address and netmask for the interface.
• For DHCP addressing, select DHCP and complete the following:

 

• For PPPoE addressing, select PPPoE, and complete the following:

Enter the administrative distance, between 1 and 255 for the 

default gateway retrieved from the DHCP server. The 

administrative distance specifies the relative priority of a route 

when there are multiple routes to the same destination. A 

lower administrative distance indicates a more preferred route.

Enable to retrieve a default gateway IP address from the 

DHCP server. The default gateway is added to the static 

routing table.

Enable to use the DNS addresses retrieved from the DHCP 

server instead of the DNS server IP addresses on the DNS 

page on System > Network > Options. On FortiWiFi-100 

units and lower, you should also enable Obtain DNS server 

address automatically in System > Network > Options. 

Enter the username for the PPPoE server. This may have 

been provided by your ISP.

Enter the password for the PPPoE server for the above user 

name.

Specify the IP address for the interface. If your ISP has 

assigned you a block of IP addresses, use one of these IP 

addresses. Alternatively, you can use, or borrow, the IP 

address of a configured interface on the router. You may need 

to do this to minimize the number of unique IP addresses 

within your network.
If you are borrowing an IP address remember the interface 

must be enabled, or up to function correctly.

Initial discovery timeout in seconds. The time to wait before 

starting to retry a PPPoE discovery. To disable the discovery 

timeout, set the value to 0.