NorthStar 961x Manual Do Utilizador
SECTION THREE - Interfacing
961 INSTALLATION MANUAL Revision A
Page 47
Figure 24: Port 1 output setup screen
Check the installation instructions of the equipment to which you’re
interfacing for any special requirements. The Northstar factory settings
will be adequate for most peripheral equipment, but the following options
are available, if needed:
interfacing for any special requirements. The Northstar factory settings
will be adequate for most peripheral equipment, but the following options
are available, if needed:
Table 6: Port setup options
Parameter
Options
OUTPUT FORMAT
(see below)
(see below)
choose OFF, 0180, 0183,
0183-R, or CDX
0183-R, or CDX
NMEA 0183 Talker ID
(see page 51)
(see page 51)
choose GP or II to make the unit
look like a GPS receiver or an
“integrated instrument” (II)
look like a GPS receiver or an
“integrated instrument” (II)
NMEA 0183 lat/lon precision
(see page 52)
(see page 52)
choose hundredths of minutes,
thousandths of minutes, or
ten-thousandths of minutes
thousandths of minutes, or
ten-thousandths of minutes
OUTPUT RATE
(see page 53)
(see page 53)
choose 1 to 199 seconds
NMEA 0183 waypoint ID as
(see page 53)
(see page 53)
choose NAMES or NUMBERS
for the identifier of waypoints
sent to the external device
for the identifier of waypoints
sent to the external device
NMEA 0183 checksums
(see page 53)
(see page 53)
choose ON or OFF for compati-
bility with some older devices
bility with some older devices
NMEA 0183 baud rate
The baud rate is fixed at 4800