NorthStar 961x Manual Do Utilizador
SECTION FOUR - Service/Maintenance
Page 62
961 INSTALLATION MANUAL Revision A
can set the differential frequency to any value between 283.5kHz and
325kHz. You can set the baud rate to any of the four standard rates: 25
bps, 50 bps, 100 bps, or 200 bps.
325kHz. You can set the baud rate to any of the four standard rates: 25
bps, 50 bps, 100 bps, or 200 bps.
To choose manual mode:
1. At the RECEIVER INFORMATION screen, press the CURSOR PAD to
highlight the BEACON FREQ field, then press the EDIT DATA key.
the cursor defaults to the MAN field.
the cursor defaults to the MAN field.
2. Use the KEYPAD to enter the desired frequency.
3. When done, press the ACCEPT key (or CANCEL to leave the option
3. When done, press the ACCEPT key (or CANCEL to leave the option
unchanged).
Manually setting baud rate
It is strongly recommended that you leave the beacon baud rate setting at
AUTO
AUTO
. To manually set the baud rate for the selected differential fre-
quency:
1. At the RECEIVER INFORMATION screen, press the CURSOR PAD to
highlight the BEACON BAUD field, then press the EDIT key.
2. Press the CURSOR PAD left or right to highlight 200, 100, 50, or 25
bps.
3. When done, press the ACCEPT key (or CANCEL to leave the option
unchanged).
Viewing GPS
status
The 961’s GPS SATELLITE STATUS screen lets you see a display of all
available satellites, including their signal strength and your expected
accuracy, as well as the frequency, baud rate, and status of DGPS trans-
mitters (961XD only). To display this information, press the STAR key
until you reach the SERVICE MENU screen, then press the GPS STATUS
key.
available satellites, including their signal strength and your expected
accuracy, as well as the frequency, baud rate, and status of DGPS trans-
mitters (961XD only). To display this information, press the STAR key
until you reach the SERVICE MENU screen, then press the GPS STATUS
key.
Figure 31: GPS satellite status screen