Garmin 3205 Manual Do Proprietário

M

AIN

 M

ENU

 > 

S

YSTEM

 T

AB

The System tab consists of five sub tabs—General, Units, Time, Comm, and 

Update.

Use the General sub tab to control system settings for system mode, speed filter, 

automatic backlight, beeper, language, simulator controls, restore factory default 

settings, and to view the software version.
The following settings and options are available:

•  System Mode—select from Normal (normal navigation) or Simulator (for 

practice only). For more information about Simulator Mode, see “

•  Speed Filter—averages speed readings. Select from Off, Auto 

(automatically controls filtering), or On (allows you to enter a value from  

1 to 255 seconds).

•  Automatic Backlight—automatically adjusts the display brightness to a 

specified level at sunrise and sunset. You can specify offset minutes for 

before sunrise and after sunset.

•  Beeper—controls the audible beep. Select from Off, Alarms Only (sounds 

for alarms/messages), or Key and Alarm (sounds for key presses and 

alarms/messages).

•  Language—sets the language for the unit’s on-screen text.
•  Services—after a new device is detected on the network, clearing the 

Auto-Detect Services check box speeds up the startup sequence. If the 

Auto-Detect Services check box is not selected and new hardware is 

added, you must select the corresponding service check box to enable the 

new hardware device.

The following soft keys are available:

•  Factory Dflts—restores all settings to Garmin’s original setup values for 

all devices on the network.

•  System Info—shows the unit’s software, basemap version, and electronic 

serial number.

•  Update Notes—shows software notes for the current software version.
To adjust the automatic backlight settings:

1.  Highlight the 

Automatic Backlight field, and press ENTER.

2.  Using the 

ROCKER, highlight On, and press ENTER.

3.  Highlight the 

Setup button, and press ENTER to open the Adjust Backlight 

window.

4.  To adjust the backlight levels 

For Day and For Night, highlight the 

corresponding slider, and press 

ENTER.