Fortinet FortiGate-30B Manual Do Utilizador

For an initial configuration, you must edit the factory configured static default route 
to specify a different default gateway for the FortiGate unit. This will enable the 
flow of data through the FortiGate unit.

For details on adding additional static routes, see the FortiGate Administration 
Guide.

Go to Router > Static.

Select Edit for the default route

In the Gateway field, type the IP address of the next-hop router where outbound 
traffic is directed.

If the FortiGate unit reaches the next-hop router through a different interface 
(compared to the interface that is currently selected in the Device field), select the 
name of the interface from the Device field.

Select OK.

Firewall policies enable traffic to flow through the FortiGate interfaces. Firewall 
policies define how the FortiGate unit processes the packets in a communication 
session. You can configure the firewall policies to allow only specific traffic, users 
and specific times when traffic is allowed.

For the initial installation, a single firewall policy that enables all traffic through will 
enable you to verify your configuration is working. On lower-end units such a 
default firewall policy is already in place. For the higher end FortiGate units, you 
will need to add a firewall policy.

The following steps add two policies that allows all traffic through the FortiGate 
unit, to enable you to continue testing the configuration on the network.

Go to Firewall > Policy.

Select Create New.

Set the following and select OK.

Go to Firewall > Policy.

Select Create New.

Select the port connected to the network.

All

Destination Interface Select the port connected to the Internet.
Destination Address All
Schedule

always

Any

Accept