Fortinet FORTIGATE-50B Instrução De Instalação

For the initial installation, a single firewall policy that enables all traffic through will 
enable you to verify your configuration is working. On lower-end units such a 
default firewall policy is already in place. For the higher end FortiGate units, you 
will need to add a firewall policy.

The following steps add two policies that allows all traffic through the FortiGate 
unit, to enable you to continue testing the configuration on the network.

Go to Firewall > Policy.

Select Create New.

Set the following and select OK.

Go to Firewall > Policy.

Select Create New.

Set the following and select OK.

Firewall policy configuration is the same in NAT/Route mode and Transparent 
mode.

Note that these policies allow all traffic through. No protection profiles have been 
applied. Ensure you create additional firewall policies to accommodate your 
network requirements.

After connecting to the CLI, you can use the following procedures to complete the 
basic configuration of the FortiGate unit. Ensure you read the section 

 before beginning.

The FortiGate unit comes preset to NAT mode. You need to switch to Transparent 
mode.

Select the port connected to the network.

All

Destination Interface Select the port connected to the Internet.
Destination Address All
Schedule

always

Any

Accept

Select the port connected to the Internet.

All

Destination Interface Select the port connected to the network.
Destination Address All
Schedule

always

Any

Accept