KitchenAid KERS807S Folheto

Página de 1
30" Freestanding and Slide-In Electric Range
®
PRODUCT MODEL NUMBERS
OVERALL DIMENSIONS
CABINET OPENING DIMENSIONS
SLIDE-IN RANGE
COUNTERTOP PREPARATION
KERS807S
KESK901S
KESS907S
KESS908S
Electrical: This range is manufactured
with the neutral terminal connected to the
cabinet. Use a 3-wire UL listed, 40- or 50-
amp power supply cord (pigtail). If local
codes do not permit ground through the
neutral, use a 4-wire power supply cord
rated at 250 volts, 40 or 50 amps and
investigated for use with ranges.The range
can be connected directly to the fused
disconnect (or circuit breaker box)
through flexible or nonmetallic sheathed,
copper or aluminum cable. A UL listed
conduit connector must be provided at
each end of the power supply cable (at the
range and at the junction box). Wire sizes
and connections must conform with the
rating of the range. A time-delay fuse or
circuit breaker is recommended.
Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only.  For complete details, see Installation
Instructions packed with product.  Specifications subject to change without notice.
The cooktop sides of the slide-in range fit over the
cutout edge of your countertop.
If you have a square finish (flat) countertop and the
opening width is 30" (76.2 cm), no countertop
preparation is required.
Formed front-edged countertops: Must have
molded edge shaved flat 3/8" (1.0 cm) from each
front corner of opening.
Tile countertops may need trim cut back 
3/8" (1.0 cm) from each front corner and/or
rounded edge flattened.
If countertop opening width is greater than 30"
(76.2 cm), adjust the 3/8" (1.0 cm) dimension.
Countertop must be level. Place level on
countertop, first side to side; then front to back. If
countertop is not level, range will not be level.
Range must be level for satisfactory baking
performance.
WI0118260
09-05-07
30"
(76.2 cm)
30 
³⁄₄"
(78.1 cm)
³⁄₈"
(1.0 cm)
 
 
e
g
n
a
R
 
n
i
-
e
d
i
l
S
 
 
e
g
n
a
R
 
g
n
i
d
n
a
t
s
e
e
r
F
30" (76.2 cm) min. 
opening width 
Cabinet door 
or hinge 
should not 
extend into 
the cutout. 
C
13" (33 cm) 
upper cabinet
depth 
13" (33 cm) 
upper cabinet
depth 
For minimum 
clearance to the 
top of the cooktop, 
see NOTE*. 
For minimum 
clearance to the 
top of the cooktop, 
see NOTE*. 
30" 
(76.2 cm) min. 
opening width  
30" 
(76.2 cm) min. 
opening width  
Junction box - 8" 
(20.3 cm) to 22" (55.9 cm) 
from either cabinet, 7" 
(17.8 cm) max. from floor 
Junction box - 8" 
(20.3 cm) to 22" (55.9 cm) 
from either cabinet, 7" 
(17.8 cm) max. from floor 
Cabinet door 
or hinge 
should not 
extend into 
the cutout. 
30" (76.2 cm) min. 
opening width 
1/4" 
(6.2 cm) radius 
both corners
22 3/4" (57.8 cm) 
opening depth
Cabinet opening dimensions shown are for
25” (64 cm) countertop depth, 24” (61 cm)
base cabinet depth and 36” (91.4 cm)
countertop height.
NOTE: 24" (61 cm) min. when bottom of wood or metal
cabinet is protected by not less than 1/4" (0.64 cm)
flame retardant millboard covered with not less than 
No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel,
0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) min. clearance between the top of the
cooking platform and the bottom of an unprotected wood
or metal cabinet.
If installing a range hood or microwave hood
combination above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
Freestanding Range  
*Range can be raised approximately 1" (2.5 cm) by adjusting 
the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm) 
countertop; front of oven door protrudes 1" (2.5 cm) beyond 
24" (61 cm) base cabinet.
Slide-in Range  
*Range can be raised approximately 1" (2.5 cm) by adjusting 
the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm) 
countertop; front of oven door protrudes 1
³⁄₄" (4.4 cm) beyond 
24" (61 cm) base cabinet.
A.
5³⁄₄" (14.6 cm)
B. 30" (76.2 cm)
C. 41
³⁄₄" (106 cm) overall 
height with leveling legs 
screwed all the way in
D. 36" (91.4 cm) cooktop trim 
height with leveling legs 
screwed all the way in*
E. 30" (76.2 cm)
F. 27
¹⁄₄" (69.2 cm) max. from 
handle to standoff at back of 
range**
G. Model/serial number plate 
(located on the right-hand side 
oven door trim)
A
B
C
D*
E
F**
G
A. 30
¹¹⁄₁₆" (77.6 cm)
B. 35
⁵⁄₈" (90.5 cm) height to
underside of cooktop edge 
with leveling legs screwed all 
the way in*
C. Model/serial number plate 
(located on the right-hand side 
oven door trim)
D 30" (76.2 cm)
E. 27¼" (69.2 cm) from handle 
to standoff at back of 
range**
F. 23" (58.4 cm) countertop 
notch to rear of cooktop
C
B*
A
D
E**
F