Anchor bea-6000 Manual Do Proprietário

GETTING STARTED - WARRANTY INFORMATION .................................................................................................. 2
SETTING UP YOUR BEACON SOUND SYSTEM ........................................................................................................ 2
CONTROLLING FEEDBACK - BEACON TRAVEL DOLLY ........................................................................................... 3
SOUND SYSTEM ACCESSORIES ............................................................................................................................... 3
BEACON SOUND SYSTEM BASIC OPERATION - OPENING & CLOSING THE LINE ARRAY ................................... 4/5
USING THE EXTERNAL AUDIO INPUT JACK ........................................................................................................... 6
OPERATING THE BUILT-IN UHF WIRELESS RECEIVER ........................................................................................... 6
OPERATING THE WIRELESS MICROPHONE/TRANSMITTER ................................................................................... 7
HAVING TROUBLE W/ YOUR SOUND SYSTEM? ...................................................................................................... 8
BEACON TECHNICAL SPECIFICATIONS ................................................................................................................... 8

No Sound 

(power LED off) 

• turn POWER switch ON

 

• charge battery or plug in AC cord

Charge Indicator LED off 

• leave plugged in for 48 hours to repair battery

No Sound 

(power LED on) 

• check for output from source

 

• make sure all cables are completely plugged in

 

• turn up volume control of input used

 

• remove plug from speaker output if not using external speaker output

Shortened Battery Life 

• charge battery fully; if battery life continues to deteriorate, contact 

Anchor Audio customer service:  (888) 444-6077

Distorted Sound 

• lower system volume control

Excessive Hum or Noise 

• use shielded cables

 

• use balanced microphone

No Sound

 (RX Indicator:  ON) 

• set MUTE switch to on 

(handheld mic only)

 

• turn up WIRELESS volume control

 

• make sure mic is plugged into body pack transmitter

No Sound 

(RX Indicator:  OFF) 

• push mic power button

 

• turn Beacon POWER switch on

 

• make sure transmitter power switch is on

 

• set receiver and transmitter to same channel

 

• replace battery in transmitter

Portable Sound Systems  •  Torrance, California

100-0149-000/4- 11/06

Rated Power Output 

300 watts AC / 60 watts DC

Max SPL @ Rated Power  110 dB
Battery 

12 Volt rechargeable, 9.0 AH

Frequency Response 

60 Hz – 15 kHz ± 3dB

Line Output 

(post fader)  isolated, 600 ohm, 1/4” phone

AC Power Reqs. 

100 – 240 VAC, 50/60 Hz, 300W max

Dimensions 

(HWD) 

26.25 x 11 x 18”/66.7 x 28 x 45.7cm

Weight 

45 pounds / 20 Kg

(Specifications subject to change without notice)

Inputs
Lo-Z Microphone 

balanced, phantom powered, XLR

Hi-Z Microphone 

unbalanced, 1/4” phone

Line 

Lo-Z balanced, 1/4” phone/RCA

Sensitivity For Rated Output
Lo-Z Microphone 

-52 dBV 

(2.5 mVrms)

Hi-Z Microphone 

-43 dBV 

(7.5 mVrms)

Auxiliary 

(line) -14 

dBV

 (200 mVrms)