Dwin hd-242 Guia Do Utilizador
23
Plasmaimage™ RS-232 Control
The RS-232 interface for the Plasmaimage
™
System can be operated from any
terminal, such as a Windows based PC running HyperTerminal.
Communication Port Set-Up Connector pin-out
Baud Rate:
Baud Rate:
9600
3 TX (Transmit Data)
Parity:
none
2 RX (Receive Data)
Stop bits:
1
5 GND (Signal Ground)
Num. of bits: 8 bits
Flow control: none
Flow control: none
Each command is enclosed in the [ ] character envelope.
Note: Sequential commands must be separated with proper delays.
Any command followed by POWER ON must be delayed 10 seconds.
Any command followed by INPUT SELECT must be delayed 1 second.
Note: Sequential commands must be separated with proper delays.
Any command followed by POWER ON must be delayed 10 seconds.
Any command followed by INPUT SELECT must be delayed 1 second.
The following table lists the commands available:
POWER CONTROL
[PON] Power on
[POFF] Power off
[PON] Power on
[POFF] Power off
ASPECT RATIO SELECT
[S1]
[S1]
Standard (4:3)
[S2]
Anamorphic or HD
[S3]
Letterbox
[S4]
Custom
RELAY CONTROL
[Y1ON] RY1 on
[Y1OFF] RY1 off
[Y2ON] RY2 on
[Y2OFF] RY2 off
[Y1ON] RY1 on
[Y1OFF] RY1 off
[Y2ON] RY2 on
[Y2OFF] RY2 off
INPUT SELECT
[I1]
[I1]
Video 1
[I2]
Video 2
[I3 ]
S-Video 1
[I4]
S-Video 2
[I5]
YCrCb 1
[I6]
YCrCb 2
[
I
7]
RGB 1
[
I
8]
RGB 2
[
I
9]
DVI 1
[
I
0]
DVI 2