Vertical ip2007 Guia De Configuração Rápida
Quick Start Guide
START HERE
It is strongly recommended that you follow
these step by step instructions to set up
and quickly start to use your Xcelerator IP
gateway.
You will need the following parts to complete the installation of your Xcelerator IP
Documentation
XCELERATOR IP GATEWAY
ANTENNA
AC POWER ADAPTER
DOCUMENTATION CD
1
UNPACKING THE BOX CONTENTS
2
INSTALLING THE XCELERATOR IP GATEWAY
If the Xcelerator IP gateway is to be wall mounted, print a
copy of the wall mount template from the documentation CD
for use in lining up the screw mounts with the mounting holes
in the gateway. To mount the Xcelerator IP on a table or other
flat surface, insert the Xcelerator IP gateway unit into the
provided stand.
copy of the wall mount template from the documentation CD
for use in lining up the screw mounts with the mounting holes
in the gateway. To mount the Xcelerator IP on a table or other
flat surface, insert the Xcelerator IP gateway unit into the
provided stand.
Next, mount the antenna to the threaded connection on the
upper side of the Xcelerator IP gateway chassis. Once
mounted, the antenna must be fully extended for proper
operation as depicted in the diagram.
upper side of the Xcelerator IP gateway chassis. Once
mounted, the antenna must be fully extended for proper
operation as depicted in the diagram.
GATEWAY STAND
3
POWER THE XCELERATOR IP GATEWAY
Once the Xcelerator IP has been mounted, attach the AC power adapter to the “Power In” connector on the interface
panel of the gateway. Plug the AC power adapter into a grounded 120VAC power source. Move the ON/OFF switch
to the ON position.
panel of the gateway. Plug the AC power adapter into a grounded 120VAC power source. Move the ON/OFF switch
to the ON position.
A blue LED above “Power” on the front of the Xcelerator IP will indicate the gateway is powered and ready to
continue with the installation of the unit.
continue with the installation of the unit.
4
STARTING TO USE THE XCELERATOR IP
Open your internet browser and type in 192.168.1.1. This is the default
address of the Xcelerator IP Admin interface. The default password is
“admin” and the default user name is “admin”.
address of the Xcelerator IP Admin interface. The default password is
“admin” and the default user name is “admin”.
On new installations, or if the system is defaulted, the Xcelerator IP will start with a configuration Wizard to assist
with the installation. Refer to the Administrator Guide for details on the programming of the Xcelerator IP.
with the installation. Refer to the Administrator Guide for details on the programming of the Xcelerator IP.
P/N 7552-00
Attach a PC or laptop to the Xcelerator IP via one of the Ethernet ports or via
a wireless connection.
a wireless connection.