Viking Range vmos200 Instrução De Instalação

VIKING RANGE CORPORATION

111 Front Street

Greenwood, Mississippi 38930 USA

(662) 455-1200

•  Before beginning, please read these instructions completely and carefully.
•  Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the built-in trim kit.

Remove the turntable from the oven cavity.

•  Because the kit includes metal parts, caution should be used in handling and installation to avoid the possibility of injury.
•  Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
•  Please observe all local and national codes and ordinances.
•  The installer should leave these instructions with the consumer who should retain for local inspector’s use and for future 

THIS BUILT-IN KIT IS DESIGNED FOR USE ONLY WITH VIKING MICROWAVE OVENS SPECIFYING BUILT-IN KIT  

VMTK270/271, VMTK300/301, OR VMTK360/361 ON THE RATING LABEL ON THE LEFT SIDE WALL OF THE OVEN 

CAVITY. 
IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE USE AND CARE MANUAL OF THE MICROWAVE 

OVEN, THEN DO NOT INSTALL THE MICROWAVE OVEN ABOVE IT OR IN ANY AREA WHERE HEAT AND STEAM 

ARE GENERATED; FOR EXAMPLE, NEXT TO OR ABOVE A CONVENTIONAL RANGE.

1) Front Frame Assembly

QTY 1

2) Bottom Duct Assembly

QTY 1

3) Screw A (1-3/16" length)

QTY 2

4) Screw B (1 3/4" length)

QTY 4