Videolarm qodc2-50na Guia Do Utilizador

1.   Remove contents from the box. 

2.   Remove the existing ceiling tile from the desired location. 

3.   Insert the loose end of the saftey cord on the dome through the

      middle hole on the edge of the housing opening (Figure 1).

  Figure 1

4.   Align the eyelet on the cord with the hole located on the inside of

      the housing tile opening.

5.   Insert the 6-32 x 1/2 round Phillips head screw through the

      hole and eyelet. Place the star lockwasher and 6-32 hex nut on

      the screw and tighten. 

6.   Fit the 2 x 2 housing tile in the desired location.  The housing   

      tile will rest on the ceiling grid.  (Be sure the grid is adequately

      supported).

Safety Cord 
goes here

CAMERAS     VOLTAGE           CURRENT       POWER

        1              24 VAC/VDC     102mA              2.5W

        2              24 VAC/VDC      210mA             5W

        3              24 VAC/VDC      331mA             7.9W

        4              24 VAC/VDC      487mA             10.9W

Use the formula below to select the correct power supply for 
cameras connected in parallel (positive to positive, negative to 
negative):

Total current for a 24 VAC system:
TOTAL CURRENT = (202mA x total number of cameras)
                                  Note: 202mA is camera plus power supply 

This chart shows the proper current needed for power supplies for 
Q-View™ cameras. Use Class 2 Power only. Input voltage must 
be 24 VAC/VDC.

1.  Make the proper connections to the incoming power. The RED 

     wire is POSITIVE (+), the BLACK wre is NEGATIVE (-) (For refer-

     ence purposes. Polarity is not important in this unit). The GREEN

     wire, labeled Ground, is GROUND for VAC or VDC connections. 

     NOTE: Connect green ground wire to earth ground (metal conduit,

                 metal stud, etc.)

2.  Attach the BNC connectors to the video in.

1. After completing installation of the housing, use the segmented

    arms to adjust each camera to the desired viewing location. 

2. Once camera adjustments are made, place the dome back into

    position to be sure cameras are not touching the inside of the 

    dome. If any do, adjust until they are clear. 

  

1.  Fine focusing:
     Fixed Lens:  Loosen the set screw in the lens mount and 
     manually rotate the lens until a clear picture is achieved. Once 
     the focus is set, retighten the set screw (Figure 2).

Figure 2

Set screw

Fixed  lens