Videolarm qrhpc2-50na Guia Do Utilizador

Twist and 
Secure

1.  This unit includes a 1 1/2" NPT housing for a standard 1 1/2" 

     NPT pipe.  The RH7C can be used with other brackets

     designed with 1 1/2" male pipe threads, such as the Videolarm 

     WM20G and WM20 wall mount brackets.

2.  Attach the housing coupling (Figure 3).

NOTE:  Pipe threads should be clean and rust free.   Use a 

                  sealer (such as Teflon™ tape or silicone sealer) on the 

                  threads.

1

Camera Power (24 VAC)

Red

2

Camera Power (24 VAC)

Orange

3

Accessory Power (24 VAC)

Yellow

4

Accessory Power (24 VAC)

Green

POWER

4.  Attach the wires from the wall to the connector provided, using the  

     wiring color code chart as a guide. 

5.  Once all wiring connections are made, place the wires inside the 

     wall mount bracket and close the access door.  Secure with the 

     screw removed earlier.

6.  Clean the outside of the dome. 

Access panel

3.  Open the access door on the bottom of the wall mount by 

     loosening the screw nearest the mounting plate (Figure 2).

Add thread 
sealing tape

1.  Mount the housing assembly to the mounting bracket and

     housing coupling.  A safety cable is included with the housing to

     temporarily hold it while making wiring connections.  Loop the 

     safety cable over one of the set screws on the housing coupling 

     and make the appropriate connections using the (2) screw-down 

     connectors supplied.

2.  Undo the safety cable and twist the housing onto the housing

     coupling.  Secure all (3) setscrews provided on the housing 

     coupling (Figure 4, next column).

3.  Clean the outside of the dome.