Alesis qs6.1 Guia De Referência

Part 6: Editing Effects

QS6.1 Reference Manual

75

 

[50]

The stereo shelving EQ provides bass and treble boost to the entire output of the QS6.1
Ñ not just the Effect Sends Ñ and is only available in Configuration 4 (Reverb+EQ)
and Configuration 5 (Overdrive+Lezlie). So if you push the EQ button while in
Configurations 1, 2, or 3, youÕll get the message ÒNOT IN CONFIGÓ.

There are four EQ parameters:

1)  Low Frequency (range: 30Hz to 180Hz)
2)  Low Frequency Gain (0dB to +12dB)
3)  High Frequency  (3kHz to 10kHz)
4)  High Frequency Boost (0dB to +9dB).

This parameter determines the cutoff frequency of the Lo EQ. Changing it will have
no audible effect unless Lo EQ Gain (see below) is set above 0dB. When that
happens, then all frequencies below and including this selection will be boosted.

This parameter controls the amount of boost that will be applied to the frequencies
selected by the Lo EQ Frequency setting (see just above).

This control adjusts the cutoff frequency of the Hi EQ. Changing it will have no
audible effect unless  Hi EQ Gain  (see just below) is set above 0dB. When that
happens, then all frequencies above and including this selection will be boosted.

This determines how much boost will be applied to the range of frequencies selected
by the Hi EQ Frequency parameter (see just above).