Partner Tech lm-12 Manual Do Utilizador

 

Prior to taking into operation your LM12 series monitor, please check whether the following 
parts are included and undamaged: 

 

1  LM12 Series Monitor 
1  CD with touchscreen drivers for DOS, Windows 95/98/NT/2K and OS/2 
1  Operator's Manual 
1  VGA cable 
1  Serial cable (Included with Touchscreen option only) 
1  Power cable 
1  Power adapter  

 

Installation of the LM12 Series Monitor 
 

The following steps are necessary for the device to function properly: 
 

1 

Switch the computer OFF. 

2 

Connect the LM-12 series monitor to the computer. (For best results, set the computers 
screen resolution to 800x600). 

3 

Switch your computer and the monitor back ON. 

4 

Adjust the display for the graphic card in the computer by means of the On Screen Display 
(OSD) AUTO TUNING feature. This step is important for getting the best picture quality. 
(section 5.2) 

5 

(Touchscreen Monitor Only) Install the touchscreen drivers for the corresponding operating 
system (chapter 4). 

 
 

 

The installation of the cables must be done with the computer switched off. Begin by 
connecting the VGA cable, the RS232 cable, audio cable then the power cable. 
 
Once connected, turn the LM12 monitor ON. After about 3 seconds, you should see the LED 
on the front panel light up green followed by an image on the screen.  
 
Important Note: 

  If the computer is in suspend or standby mode the LED will be red. If the SVGA cable 

between the Monitor and computer is disconnected, the LED lights up red.