Canon 430 Manual Do Utilizador
120
The camera will not operate correctly if you connect it to your computer
before installing the driver and software. If this happens, please refer to
the Troubleshooting section of the Software Starter Guide.
before installing the driver and software. If this happens, please refer to
the Troubleshooting section of the Software Starter Guide.
• You do not need to turn off the camera or computer power when
making a USB connection.
• Please refer to your computer’s manual for information regarding the
location of the USB port.
• You are recommended to use a fully charged battery pack or AC
Adapter Kit ACK500 (sold separately) to power the camera when
connecting to a computer (pp. 18, 140).
connecting to a computer (pp. 18, 140).
• All procedures performed with a connection to a USB 2.0 compliant
board are not guaranteed.
1
Install the driver and the software applications bundled
on the Canon Digital Camera Solution Disk.
on the Canon Digital Camera Solution Disk.
Please see the Software Starter Guide for the installation procedures.
2
Use the supplied interface cable to connect the computer's
USB port to the camera's DIGITAL terminal.
USB port to the camera's DIGITAL terminal.
• To connect the interface cable to the camera's DIGITAL terminal, lift the
terminal cover with a fingernail under its upper edge and insert the
connector until it clicks into place.
connector until it clicks into place.
• Always grasp the connector’s sides to remove the interface cable from
the camera's DIGITAL terminal.
IMPORTANT
You must install the software and driver bundled on the supplied
Canon Digital Camera Solution Disk onto your computer before
connecting the camera to a computer.
Canon Digital Camera Solution Disk onto your computer before
connecting the camera to a computer.
USB Port
DIGITAL Terminal
Interface Cable