Canon 430 Manual Do Utilizador

Página de 163
59
Shooting
• When you use flash photography at higher ISO speeds, the chances 
of white streaks appearing in the image increase the closer you 
approach to the subject.
• Since a slow shutter speed is selected in dark places when the flash 
is set to Off or Slow Synchro, take care to avoid blurring the image.
- Shooting in 
 Mode
Be careful to hold the camera still to avoid camera shake.
- Shooting in 
 or 
 Mode
Fix the camera to a tripod to shoot in these modes since the 
shutter speed will be slower than in the 
 mode. If an image is 
dark in 
 mode, reshooting it in 
 mode will make it brighter.
• The flash can be fired when the indicator lights a steady orange after 
pressing the shutter button halfway.
• The flash may take up to approximately 10 seconds to charge. The 
recharging time will vary with such factors as the shooting 
conditions and battery charge. Shots cannot be taken while the flash 
is charging.
• The flash fires twice. The main flash follows a preparatory pre-flash. 
The exposure reading obtained from the subject with the pre-flash is 
used to set the optimal flash intensity for the main flash, which is 
used to capture the image.
• When using the flash, be sure to shoot from at least 46 cm (1.5 ft.) 
away from your subject for standard photography and at least 30 cm 
(1.0 ft.) for macro photography.
Red-eye Reduction
• Light reflecting back from eyes can make them appear red when the 
flash is used in dark areas. Under these conditions, use the red-eye 
reduction mode. For this mode to be effective, the subject must be 
looking right at the red-eye reduction lamp. Try asking them to look 
directly at the lamp. Even better results can be obtained by 
increasing the lighting in indoor settings or approaching closer to 
the subject.
• The shutter will not activate for approximately 1 second after the red-
eye reduction lamp fires in order to improve the effect (excluding 
when using the quick shot function). If you want a more immediate 
shutter response, set the flash to 
 or