Canon iPF9400 Manual
Cause
Corrective Action
If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
Because the Platen is soiled with ink or other substances, the size of the clear film cannot
be detected.
be detected.
Open the Top Cover and clean the entire Plat-
en.
en.
Insufficient paper for job
Insufficient paper for job
Cause
Corrective Action
The printer has received a print job longer than the amount of roll paper left when ManageR-
emainRoll in the Control Panel menu is On.
emainRoll in the Control Panel menu is On.
Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
When using the Media Take-up Unit, press ▲
or ▼ to select Print, and then press the OK
button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.
the OK button to resume printing.
When using the Media Take-up Unit, press ▲
or ▼ to select Print, and then press the OK
button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.
Press ▲ or ▼ to select Change Paper, and
then press the OK button.
Change the Paper Source of the printer driver,
or replace the roll with a roll that has enough
paper for the print job, and then printt.
When using the Media Take-up Unit, press ▲
or ▼ to select Stop Printing, and then press
the OK button to stop printing.
Remove the printed document from the Media
Take-up Unit, replace the roll with a roll that
has enough paper for the print job, and then try
printing again.
then press the OK button.
Change the Paper Source of the printer driver,
or replace the roll with a roll that has enough
paper for the print job, and then printt.
When using the Media Take-up Unit, press ▲
or ▼ to select Stop Printing, and then press
the OK button to stop printing.
Remove the printed document from the Media
Take-up Unit, replace the roll with a roll that
has enough paper for the print job, and then try
printing again.
Press ▲ or ▼ to select Stop Printing or press
the Stop button to stop printing.
the Stop button to stop printing.
This paper cannot be used as size is not supported.
This paper cannot be used as size is not supported.
Cause
Corrective Action
Paper that is too large for the printer has been loaded.
Lift the Release Lever and load paper of the correct size.
iPF9400
Insufficient paper for job
Error Message
Messages regarding paper
913