LXE mx6 Guia De Referência
E-EQ-MX6RG-E
MX6 Reference Guide
Appendix C MX6 Multicharger
Introduction
The Multicharger has four slots that fully charge a main battery in four hours. The charging slots
work independently to control the charging of individual battery packs. Status LEDs at each
charging slot indicate battery charge process.
work independently to control the charging of individual battery packs. Status LEDs at each
charging slot indicate battery charge process.
The right-most slot can be used for charging or charging/analyzing a battery. The charge/analyze
slot has a Status LED that indicates charge status and a Battery Capacity Indicator LED that
indicates analyze status. The analyze slot begins the analyze process on the battery if the Analyze
button is pressed once the battery has been seated in the slot.
slot has a Status LED that indicates charge status and a Battery Capacity Indicator LED that
indicates analyze status. The analyze slot begins the analyze process on the battery if the Analyze
button is pressed once the battery has been seated in the slot.
LXE recommends all MX6 battery packs be Analyzed on a monthly basis. Analyzing will reset
the internal battery charge indicator circuit, "the gas gauge", as well as analyze the battery.
the internal battery charge indicator circuit, "the gas gauge", as well as analyze the battery.
The multicharger must be connected to an AC power source and the power switch turned on
before charging/analyzing can occur.
before charging/analyzing can occur.
The multicharger should be located in an area where it:
•
Is not in high traffic areas.
•
Has enough clearance to allow easy access to the power and ports on the back of the
device.
device.
•
Is protected from rain, dust or inclement weather. This device is intended for indoor use
only.
only.