Ricoh 2035e Manual Do Utilizador
Appendix
96
9
❖
❖
❖
❖ Setting timeout
You can specify the timeout inter-
val in use when receiving data
from the network.
val in use when receiving data
from the network.
msh> diprint [30~65535]
Note
❒ The default is 300 seconds.
❒ If 0 is set, timeout is disabled.
❒ If 0 is set, timeout is disabled.
❖
❖
❖
❖ Bidirectional configuration for the di-
rect printing port
Use this setting to configure
whether the direct printing port is
bidirectional or not. The default is
“off”.
whether the direct printing port is
bidirectional or not. The default is
“off”.
msh> diprint bidirect {on
| off}
| off}
Note
❒ If you select [on], SmartNet-
Monitor for Client or Standard
T C P / I P o n W i n d o w s 2 0 0 0
might not work correctly.
T C P / I P o n W i n d o w s 2 0 0 0
might not work correctly.
SMB
Use the "smb" command to configure
or delete the NetBEUI settings such as
the computer name or workgroup
name.
or delete the NetBEUI settings such as
the computer name or workgroup
name.
msh> smb parameter
Note
❒ You cannot use a computer name
starting with "RNP" or "rnp".
ROUTE
Use the "route" command to control
the routing table.
This command allows you to config-
ure and display routing information.
You can change the network configu-
ration from remote computers using
this command.
the routing table.
This command allows you to config-
ure and display routing information.
You can change the network configu-
ration from remote computers using
this command.
Note
❒ The maximum number of routing
tables is 16.
*1
IP address
Parameter
Settings
comp
Your computer name consist-
ing of up to 15 characters
ing of up to 15 characters
group
Workgroup name consisting
of up to 15 characters
of up to 15 characters
comment
Comment consisting of up to
31 characters
31 characters
clear comp
Clears the computer name
clear group
Clears the Workgroup name
clear com-
ment
ment
Clears comment
Commands Topics of setting
gateway
Adds a host/network route
to “destination”, and a gate-
way address to “gateway” in
the table. Host becomes the
default.
to “destination”, and a gate-
way address to “gateway” in
the table. Host becomes the
default.
Deletes a host/network route
from the table. Host becomes
the default.
from the table. Host becomes
the default.
}
Displays only route informa-
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
on/off
You can turn the specified
destination on or off. Host be-
comes the default.
destination on or off. Host be-
comes the default.
You can set the default gate-
way address.
way address.
route flush
Deletes all routing informa-
tion.
tion.