Ricoh CL5000 Guia Da Instalação
1394 Interface Unit Type 4510
39
1
LLLL
Tighten the two screws that you
removed in step
removed in step
to fasten the
controller board back into its
original position.
original position.
Use a coin to fasten it securely.
MMMM
Important
❒ Do not shake the removed car-
tridge. It may cause dust to fall
off.
off.
NNNN
. First, in-
sert the projections on the cover to
the holes on the printer (
the holes on the printer (
A
A
A
A), and
then push it down (
B
B
B
B).
Note
❒ After finishing installation, you
can check whether the 1394 In-
terface Unit is installed proper-
ly. Print the configuration page
f ro m t h e " L i s t / T e s t P ri n t "
menu. If it is installed properly,
you will see "Installed" for
"IEEE1394".
terface Unit is installed proper-
ly. Print the configuration page
f ro m t h e " L i s t / T e s t P ri n t "
menu. If it is installed properly,
you will see "Installed" for
"IEEE1394".
❒ If the 1394 Interface Unit is not
installed properly, "Not In-
stalled" is shown. In such a case,
reinstall from step
stalled" is shown. In such a case,
reinstall from step
. If you can-
not install it properly even after
reinstallation, contact your sales
or service representative.
reinstallation, contact your sales
or service representative.
Reference
See "Using the Control Panel" in
the Administrator Reference for
printing the configuration page.
See "Using the Control Panel" in
the Administrator Reference for
printing the configuration page.
ZESH753J
ZESH761J
ZESH218J