Ricoh CL3000 Guia Da Instalação
Options
36
1
Note
❒ The removed screws will be
used in step
G
.
❒ Lift the end of USB2.0 Interface
Unit (
A), and then remove it
from the controller board (
B).
FFFF
Attach the Network Interface
Board. Insert the end of the Net-
work Interface Board to the open-
ing (
Board. Insert the end of the Net-
work Interface Board to the open-
ing (
A
A
A
A), and then push down
until it clicks (
B
B
B
B).
Confirm that the Network Inter-
face Board is firmly connected to
the controller board.
face Board is firmly connected to
the controller board.
GGGG
Fasten the Network Interface
Board on the controller board us-
ing the screws that you removed
in step
Board on the controller board us-
ing the screws that you removed
in step
EEEE
.
HHHH
Align the controller board to the
top and bottom rails, and then
push in slowly until it stops.
top and bottom rails, and then
push in slowly until it stops.
Note
❒ When installing other options
on the controller board, do not
close the controller board, but
go to the steps for installing the
option.
close the controller board, but
go to the steps for installing the
option.
Important
❒ The printer may not work prop-
erly if the controller board is not
set properly.
set properly.
IIII
Fasten the controller board to the
printer with the two screws that
printer with the two screws that
ZHBP450E
1
2
ZHBPA050E
1
2
ZHBPC060E
ZHBPA070E
AresPGBOptionSetup-F_FM.book Page 36 Monday, July 29, 2002 1:12 PM