Haier hlf11e Manual Do Utilizador

1. Remove the screws securing the terminal block access cover 

and the strain relief mounting bracket located on the back of the 

dryer upper corner.

2. Install a U.L. approved strain relief into the power cord entry hole 

of the mounting bracket. Finger tighten the nut only at this time.

3. Thread a U.L. Approved 30 Amp. Power cord, NEMA 10-30 Type

SRDT, through the strain relief.

4. Attach the power cord neutral (center wire) conductor to the silver 

colored center terminal on the terminal block. 

Tighten the screw securely.

5. Attach the remaining two power cord outer conductors to the 

outer brass colored terminals on the terminal block. Tighten both 

screws securely. Warning: Do not make a sharp bend or crimp

wiring/conductor at connections.

6. Reattach the strain relief mounting bracket to the back of the dryer 

with two screws. Tighten screws securely.

7. Tighten the screws securing the cord restraint firmly against the 

power cord.

8. Tighten the strain relief nut securely so that the strain relief 

does not turn.

9. Reinstall the terminal block cover.

This appliance must be connected to a ground metal,

permanent wiring system, or an equipment-grounding

conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or
lead on the appliance.

green
ground
screw

green
neutral
ground
wire

silver terminal

nut

tighten nut
to these threads

power cord

strain relief

mounting bracket