Newco moo-cafe Guia Do Utilizador
11
Sanitation
Cleaning & Sanitizing Instructions:
T
Sanitizing
TT
: All food dispensing units should be sanitized periodically. All parts
to be sanitized must be cleaned first.
To prepare a sanitizing solution: ADD 2 TSP. OF LIQUID CLOROX BLEACH (5.25%
CONCENTRATION) TO 1 GALLON OF WATER AT
ROOM TEMPERATURE (70°- 90°F).
Note: Always start with an unopened bottle of Clorox Bleach since the solution
from an opened bottle has a short life span.
• Soak all parts for a minimum of 3 min. in the sanitizing solution.
• Let all sanitized parts drain and dry naturally. DO NOT WIPE THEM DRY.
• Before using the sanitized unit (or parts) with foodstuffs, rinse all parts
thoroughly with water.
Water pipe connecting and fixtures directly connected to a potable water supply
shall be sized, installed, and maintained in accordance with
Federal, Sate, and Local codes (section 7).
To prepare a sanitizing solution: ADD 2 TSP. OF LIQUID CLOROX BLEACH (5.25%
CONCENTRATION) TO 1 GALLON OF WATER AT
ROOM TEMPERATURE (70°- 90°F).
Note: Always start with an unopened bottle of Clorox Bleach since the solution
from an opened bottle has a short life span.
• Soak all parts for a minimum of 3 min. in the sanitizing solution.
• Let all sanitized parts drain and dry naturally. DO NOT WIPE THEM DRY.
• Before using the sanitized unit (or parts) with foodstuffs, rinse all parts
thoroughly with water.
Water pipe connecting and fixtures directly connected to a potable water supply
shall be sized, installed, and maintained in accordance with
Federal, Sate, and Local codes (section 7).
Automatic Sanitation Cycle:
Sanitation cycle waits for water temp to reach 160 deg F. min.
Sanitation cycles are performed at power up, 1 hr after the
Last product dispense, and 24 Hrs after the last sanitation cycle.
Once a 24 Hr sanitation cycle has been performed, no more
sanitation cycles will take place until initiated by a dispense or
another power-up.
Sanitation cycle lasts for approx 6 seconds, all three hot water
dispense valves open and the whipper motors run. Sanitation
cycle may be cancelled by pressing any button on the display
board.
Sanitation cycle can be manually initiated by pressing the right
button on the display board. Cleaning cycle will initiate as above.
Sanitation cycles are performed at power up, 1 hr after the
Last product dispense, and 24 Hrs after the last sanitation cycle.
Once a 24 Hr sanitation cycle has been performed, no more
sanitation cycles will take place until initiated by a dispense or
another power-up.
Sanitation cycle lasts for approx 6 seconds, all three hot water
dispense valves open and the whipper motors run. Sanitation
cycle may be cancelled by pressing any button on the display
board.
Sanitation cycle can be manually initiated by pressing the right
button on the display board. Cleaning cycle will initiate as above.