Clover cdr-4010 Guia Do Utilizador
- 46 -
10. PAL/NTSC Selection
10.1 PAL/NTSC
Selection
PAL or NTSC is set at the factory according to the country where the system is
shipped. When necessary, it can be reset in following manner.
Turn off the system. Unscrew and remove the cover.
Reset the J1 jumper (NTSC : open, PAL : close)
Reassemble the cover.
Turn on the system and format the HDD (See page 29 for more details).
11 NETWORKING
11.1 Requirements
CDR4010 DVR set
PC
Required Specifications
1. OS : Microsoft Windows 98, Windows 2000, Windows XP
2. CPU : PENTIUM-4 1.8GB or higher
3. MEMORY : 512Mb
4. 1024x768 Display Resolution
32 Bit Color
5. Internet or LAN connection
6. TCP/IP installed
5. Internet or LAN connection
6. TCP/IP installed
Cable
1.
Direct connection to PC : Twist cable
2. Connection Via hub or router : Direct cable
(Refer to Fig. 6-7 for details of the cables)
Note. After installing the additional HDD, formatting the new
drive should be preformed. See 8.5(Setup) for details.
Note. When this setting is changed, you will lose all of your
recorded data. You should also reset the system properly
after this procedure.
after this procedure.