Nortel 4134 Instrução De Instalação
60
Installing Secure Router 4134 hardware components
Installing the internal VPN/IPSec module
Use the procedure in this section to install an internal VPN/IPSec module. If
you are replacing a VPN/IPSec module, also see
you are replacing a VPN/IPSec module, also see
.
Prerequisites
•
Ensure you have a VPN/IPSec module ready to install before opening
the service access panel.
the service access panel.
•
Ensure you have a Phillips #2 screwdriver.
•
Ensure the Secure Router 4134 has the power switched off.
Procedure steps
Step
Action
1
Remove the two screws at the rear of the Secure Router 4134 that
hold the service access panel secure. Remove these two screws
only. See the following figure.
hold the service access panel secure. Remove these two screws
only. See the following figure.
2
Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
Secure Router 4134.
3
Locate the internal VPN/IPSec module connector slot.
4
Holding the VPN/IPSec module by its edges, align the connector
with the slot on the Main Board, pushing down gently, but firmly,
to seat the module.
The following figure shows the location for installing the VPN/IPSec
module.
with the slot on the Main Board, pushing down gently, but firmly,
to seat the module.
The following figure shows the location for installing the VPN/IPSec
module.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301
01.02
Standard
10.0
7 August 2007
Copyright © 2007, Nortel Networks
.