Nortel 100 Manual Do Utilizador
Chapter 3 Instant Internet 400 hardware installation
37
Setting Up the BayStack Instant Internet 400 Unit
2
Attach one end of the communications cable (modem, ISDN, T1, DDS,
Ethernet, token ring) to the appropriate connector on the Instant Internet unit.
Ethernet, token ring) to the appropriate connector on the Instant Internet unit.
3
Attach the other end of the communications cable to the appropriate source
(phone jack, ISDN jack, T1 jack, DDS jack, cable modem, or external router).
(phone jack, ISDN jack, T1 jack, DDS jack, cable modem, or external router).
4
Attach the Instant Internet unit to a hub on your LAN using an Ethernet cable
(attach to Eth1) or a token ring cable (attach to Tok1).
(attach to Eth1) or a token ring cable (attach to Tok1).
5
Plug the power cord into the rear panel of the Instant Internet unit.
6
Plug the power cord into an AC wall outlet.
7
Turn on the Instant Internet unit.
When you turn on your Instant Internet 400 unit, the LEDs on the front panel
illuminate. LED #2 glows amber when the unit is ready for setup. For
information about setting up your unit, see Installing the BayStack Instant
Internet Management Software Version 7.11
illuminate. LED #2 glows amber when the unit is ready for setup. For
information about setting up your unit, see Installing the BayStack Instant
Internet Management Software Version 7.11
Mounting your Instant Internet unit in a rack
To install your Instant Internet in an equipment rack, you will need a Phillips
screwdriver (not included) and the brackets, screws, and washers provided in the
rack mounting kit.
screwdriver (not included) and the brackets, screws, and washers provided in the
rack mounting kit.
To mount your Instant Internet 400 in a rack:
1
.
Note: A token ring cable is not included with your Instant Internet
package.
package.