Lowrance lcx-104c Guia De Utilização
29
Speed sensor mounting configuration:
side view (left) and rear view (right.)
If the base of the transom has a radius, fill the gap between the tran-
som and the sensor with the caulking compound. This will help ensure
a smooth water flow.
som and the sensor with the caulking compound. This will help ensure
a smooth water flow.
Route the sensor's cable through or over the transom to the sonar unit.
If you need to drill a hole in the transom to pass the connector through,
the required hole size is 7/8".
CAUTION:
If you need to drill a hole in the transom to pass the connector through,
the required hole size is 7/8".
CAUTION:
If you drill a hole in the transom for the cable, make sure it is lo-
cated above the waterline. After installation, be sure to seal the
hole with the same marine grade above- or below-waterline seal-
ant used for the screws.
cated above the waterline. After installation, be sure to seal the
hole with the same marine grade above- or below-waterline seal-
ant used for the screws.
The sensor is now ready for use. Connect the sensor to the in-line con-
nector on the MY-4X adapter cable. If you have any questions concern-
ing the installation of the sensor, please contact your local boat dealer.
nector on the MY-4X adapter cable. If you have any questions concern-
ing the installation of the sensor, please contact your local boat dealer.
GPS Antenna/Receiver Module
This unit's package includes the LGC-12w GPS module. This device
contains the unit's external antenna and receiver for GPS and WAAS
signals. The antenna/receiver module comes with a 25-foot extension
cable. This module can be mounted on a flat surface or pole, or a mag-
net is included for temporary mounting on any ferrous surface. (The
LGC-12s GPS module sold with earlier Lowrance equipment will work
with your unit, but it will not receive WAAS signals.)
contains the unit's external antenna and receiver for GPS and WAAS
signals. The antenna/receiver module comes with a 25-foot extension
cable. This module can be mounted on a flat surface or pole, or a mag-
net is included for temporary mounting on any ferrous surface. (The
LGC-12s GPS module sold with earlier Lowrance equipment will work
with your unit, but it will not receive WAAS signals.)
LGC-12 Module, bottom view (left) and top view (right).
Transom
Bottom of hull
Bottom of hull