Extreme reachnxt 100-8t Guia De Configuração Rápida

ReachNXT

™

 100-8t Quick Start Guide

●

Optional AC adapter, if the ReachNXT 100-8t will be powered using AC power

If an SFP module will be used for the uplink connection to the ExtremeXOS switch, you must power 
the ReachNXT 100-8t using AC power.

●

Kensington lock (not supplied) to secure the ReachNXT 100-8t to its location using its Kensington 
lock slot

To install the ReachNXT 100-8t port extender:

If an SFP module will be used for the connector to the uplinked ExtremeXOS switch, install the SFP 
module in the ReachNXT 100-8t (port 9x) according to the instructions supplied with the module.

You must use the AC power adapter to power the ReachNXT 100-8t when using the SFP uplink.

Set the ReachNXT 100-8t in its installed location, such as on a table in a conference room.

To use the optional magnet mounting kit to install the ReachNXT 100-8t in a fixed location, follow 
the procedure under 

.

To secure the ReachNXT 100-8t in its location using a Kensington lock, follow the instructions 
provided with the Kensington lock.

Insert the locking device into the Kensington lock slot on the ReachNXT 100-8t rear panel (

), 

then turn it in the locking direction.

If the ReachNXT 100-8t will be powered using AC power, connect the optional AC adapter to the 
power socket on the ReachNXT 100-8t (labeled PWR), and plug the AC adapter into a wall outlet.

The optional magnet mounting kit allows you to mount the ReachNXT 100-8t in a fixed location using 
magnets attached to the switch. The magnet mounting kit contains the following items:

●

Two magnets

●

Two rubber stabilizing pads

●

Mounting plate

●

Screws and anchors

The magnets are attached to two slots on the bottom of the ReachNXT 100-8t unit (

). At the 

other two corners, rubber stabilizing pads prevent the unit from rocking.

Kensington lock slot

RCH_006