Extreme 3804 Guia Do Utilizador

S

UMMIT

 S

WITCH

 I

NSTALLATION

 

AND

 U

SER

 G

UIDE

9-13

C

ONFIGURING

 DHCP/BOOTP R

ELAY

 describes the commands used to configure the IP route table.

Table 9-2: Route Table Configuration Commands

enable iproute sharing

Enables load sharing if multiple routes to the 
same destination are available. Only paths with 
the same lowest cost are shared. The default 
setting is enabled.

config ipqos add <ip_destination_address> 
<mask> qosprofile <qosname>

Adds a QoS profile to an IP destination 
address.

config ipqos delete <ip_destination_address> 
<mask>

Deletes a QoS profile from an IP destination 
address.

config iproute add <ipaddress> <mask> 
<gateway> <metric>

Adds a static address to the routing table. Use 
a value of 255.255.255.255 for 

mask

 to 

indicate a host entry

config iproute delete <ipaddress> <mask> 
<gateway>

Deletes a static address from the routing table.

config iproute add blackhole <ipaddress> 
<mask>

Adds a 

blackhole

 address to the routing 

table. All traffic destined for the configured IP 
address is dropped, and no Internet Control 
Message Protocol (ICMP) message is 
generated.

config iproute delete blackhole <ipaddress> 
<mask>

Deletes a 

blackhole

 address from the routing 

table.

config iproute add default <gateway> 
{<metric>}

Adds a default gateway to the routing table. A 
default gateway must be located on a 
configured IP interface. If no metric is 
specified, the default metric of 1 is used.

config iproute delete default <gateway>

Deletes a default gateway from the routing 
table.

disable iproute sharing

Disables load sharing for multiple routes.

Summit.bk : 9ROUT.FM  Page 13  Thursday, June 18, 1998  9:27 AM