Intermec 2430 Guia Do Utilizador
Chapter 6—Configuration Command Reference
Trakker Antares 2400 Family System Manual
191
Syntax: YJn.data
where n is:
1
COM1 serial port
2
COM2 serial port (246X and 248X terminals only)
3
COM3 serial port (242X terminals only)
4
COM4 serial port (242X, 2455, and 248X terminals only)
An acceptable value for data is any ASCII character.
Disabled
No characters, no ACK or NAK transmitted
Enabled
\x06 (hexadecimal value for ACK)
Default: No characters (Disabled)
Menu System: Main Menu > Configuration Menu > Communications Menu > Serial
Port
Bar Codes: To disable handshake, scan one of these bar codes:
Note: To scan these bar code labels, you must configure the terminal to
use Code 39 in Full ASCII mode. For help, see “Code 39” on page 146.
use Code 39 in Full ASCII mode. For help, see “Code 39” on page 146.
Disable Handshake for COM1
Disable Handshake for COM2
*$+YJ1.*
*$+YJ2.*
*$+YJ1.*
*$+YJ2.*
Disable Handshake for COM3
Disable Handshake for COM4
*$+YJ3.*
*$+YJ4.*
*$+YJ3.*
*$+YJ4.*
Or: To enable handshake, scan one of these bar codes:
Enable Handshake (Set to ACK) for COM1
*/D/KYJ1/N$F*
*$+YJ1.$F*
Enable Handshake (Set to ACK) for COM2
*/D/KYJ2/N$F*
*$+YJ2.$F*
Enable Handshake (Set to ACK) for COM3
*/D/KYJ3/N$F*
*$+YJ3.$F*
Enable Handshake (Set to ACK) for COM4
*/D/KYJ4/N$F*
*$+YJ4.$F*