Intermec 9710 Guia De Referência
C d 39
IBM 316X and 319X Series
45
IBM 316X and 319X Series
This section covers these workstations:
• IBM 3161
• IBM 3191
• IBM 3162
• IBM 3192
• IBM 3163
• IBM 3193
• IBM 3164
• IBM 3196
• IBM 3197
The individual Wedge Interface Guide corresponding to this section is part number
054525.
054525.
Cables
Connecting the reader to one of these workstations requires two cables: a keyboard
cable and a terminal cable. The interface kit contains both the keyboard and terminal
cables. If you need to order a replacement cable, use the part numbers listed below:
cable and a terminal cable. The interface kit contains both the keyboard and terminal
cables. If you need to order a replacement cable, use the part numbers listed below:
• Wedge interface kit (P/N 054524)
• Keyboard cable (P/N 054523)
• Terminal cable (P/N 054522)
• Keyboard cable (P/N 054523)
• Terminal cable (P/N 054522)
Power Supply
The reader does not require an external power supply to work with the workstations. Set
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
Configuring the Reader
Scan the appropriate label to configure the reader for your workstation. After the label is
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
To Set Workstation Configuration to
Scan This Bar Code
IBM 3161
*$+TA118*
*$+TA118*