Citel 3000 Guia Do Utilizador
EXTender 3000 System Administrator’s Guide (Definity)
A - AT Command Set
Page 109
Table 26: COM1 Port Configuration Commands
Command
Description
Values
@P2=
DTE speed - the speed at
which the COM1 serial port
is to run.
which the COM1 serial port
is to run.
2400, 4800, 9600, 115.2 19200, 38400,
57600<default>, 115200
57600<default>, 115200
@P3=
Parity
N - none <default>
O – odd
E – even
O – odd
E – even
@P4=
Number of data bits.
7 or 8 <default>
@P6=
Number of stop bits
0 - 1 stop bit <default>
2 - two stop bits
2 - two stop bits
Table 27: Terminal Adapter Configuration Commands
Command
Description
Values
En
Local echo
n = 0- Disabled
1- Enabled<default>
1- Enabled<default>
Qn
Status messages - are AT command responses and
connection progress messages displayed.
connection progress messages displayed.
n = 0- Enabled <default>
1- Disabled
1- Disabled
Vn
Message format.
n = 0- Numeric messages
1- Verbose messages <default>
1- Verbose messages <default>
Wn
Carrier/Protocol result codes - are carrier and pro-
tocol messages displayed.
tocol messages displayed.
n = 0- Disabled<default>
1- Enabled
1- Enabled
Xn
Connect Messages - allows only a subset of all
result messages to be displayed.
result messages to be displayed.
n = 0- Enable result codes 0-4
1- 0-4, 17, 19,
2- All result codes <default>
1- 0-4, 17, 19,
2- All result codes <default>
Refer to the AT result codes sec-
tion for a description of the codes.
tion for a description of the codes.
S0=
Auto answer - does the module automatically
answer an incoming call or wait for the AT answer
command to be issued before answering.
answer an incoming call or wait for the AT answer
command to be issued before answering.
0 - auto answer disabled
<default>
1-255 auto answer enabled
<default>
1-255 auto answer enabled
S1=
Ring count. The value of this command never
increments.
increments.
000 (Compatible with BitSURFR
command lines)
command lines)