Citel 3000 Guia Do Utilizador
EXTender 3000 System Administrator’s Guide (Definity)
Ethernet Data Type Configuration – Office Module
Page 81
menu. If compression is enabled on both sides of the link, Stac Compression can provide up to a 2:1 com-
pression of the original data.
pression of the original data.
Note: If Stac Compression is disabled in either one of the remote or office Modules, compression will not be
used in either direction on the PPP connection.
used in either direction on the PPP connection.
Configuring STAC Compression
From the Configure PPP menu:
1.
Select number 1 for Stac Compression. The Configure PPP menu displays the current status (Enabled,
or Disabled).
or Disabled).
2.
Press Return. The Stack Compression menu appears. This menu allows you to Enable or Disable the
stack compression.
stack compression.
Connection Authentication
The Extenders allow authentication to be disabled, required only from the remote unit, required only from
the switch unit, or required from both units. The three receive authentication settings (None, PAP, and
CHAP) specify the authentication information that the Extender requires the other unit to send to it. The
three send authentication settings specify the authentication information that the Extender will send to the
other unit, if requested.
Authentication may be disabled when initially configuring the Extenders’ ISDN connections and/or for trou-
bleshooting the ISDN connection. Once the Extenders are ready for general use, it is recommended that
authentication is enabled on both units.
the switch unit, or required from both units. The three receive authentication settings (None, PAP, and
CHAP) specify the authentication information that the Extender requires the other unit to send to it. The
three send authentication settings specify the authentication information that the Extender will send to the
other unit, if requested.
Authentication may be disabled when initially configuring the Extenders’ ISDN connections and/or for trou-
bleshooting the ISDN connection. Once the Extenders are ready for general use, it is recommended that
authentication is enabled on both units.
Setting Receive Authentication
Receive Authentication specifies the authentication protocol required from the Remote Module to authenti-
cate the connection. If the other system does not support the required authentication protocol, the connection
will fail.
Remote Module Office Module
cate the connection. If the other system does not support the required authentication protocol, the connection
will fail.
Remote Module Office Module
Send Authentication
Receive Authentication
From the Configure PPP menu:
a) Select Receive Authentication.
The following sub-menu will appear:
1.
None
2.
PAP
3.
CHAP
b) Highlight the desired local authentication option and press Enter to select.