Citel 6000 Guia Da Instalação

EXTender 6000 Quick Installation Guide

 

28

 

 

IP Network (RVP_IP) 

This section of the manual provides the necessary information to configure the EXTender for connection 
within an IP network. 
 
Note: The units are programmed at the factory with RVP_Direct “default” settings. The Type parameter 
must be set to RVP_Over_IP. 
 

IP Network

Punch Block

Punch Block

PBX

Ethernet

RJ21

Ethernet

•  The Gateway (at the corporate site) and the EXTender (at the branch office) must be installed 

properly and the network link between both devices must be operational. 

•  The network administrator must assign IP address information for both units. 

Ensure that the correct TCP/UDP ports have been opened to allow the EXTender to connect to the 
Gateway through your company firewall. The following TCP/UDP port requirements must be met: 
 
The EXTender 6000 uses even numbered ports 12,288 to 12,544. The port numbers start at 12,288 and 
increment by 2 to the total number of ports used. For example, if you have an 8 port EXTender 6000 with 
3 telephones connected, ensure that ports 12,288, 12,290, and 12,292 are opened. 
The Gateway unit uses TCP/UDP port 2698. 

Set Connect Parameters 

Configure the Remote Unit to communicate over 
the IP net-work. 

Set IP Parameters 

Configure the Remote Unit with required IP 
information.