Citel 6000 Guia Da Instalação
EXTender 6000 Quick Installation Guide
34
Remote Telephone Messages
The following messages appear on the remote telephone display connected to the Remote Unit when a
connection attempt fails. The telephone shows Connect Error, followed by a message. Table 9:
Connect Error Messages, on the next page, contains the possible Connect Error messages.
connection attempt fails. The telephone shows Connect Error, followed by a message. Table 9:
Connect Error Messages, on the next page, contains the possible Connect Error messages.
Table 9:
Connect Error Messages
Message Description
Action
Already connected
Remote port is already connected.
Reset port at the Gateway.
Assigned port
Busy (see note)
Busy (see note)
The switch port is being used by
another user.
another user.
Wait until port is available or
reset port on the
PBXgateway and try to re-
connect.
reset port on the
PBXgateway and try to re-
connect.
Assigned port
Down (see note)
Down (see note)
The switch port is not available, due
to problems (green flicker) with the
port.
to problems (green flicker) with the
port.
Check port connection at the
PBXgateway.
PBXgateway.
Carrier Lost
(see note)
(see note)
Displayed if the network connection
to the PBX is lost.
to the PBX is lost.
Check network links.
Attempt to reconnect after
network is up and running.
Attempt to reconnect after
network is up and running.
Connect rejected
The system rejects the connection
request.
request.
Make sure the Connect
Password is correct.
Check network links.
Attempt to reconnect.
Password is correct.
Check network links.
Attempt to reconnect.
Connect Timeout
The EXTender cannot connect to
the
PBXgateway.
the
PBXgateway.
Check WAN connection on
the unit
the unit
Network disabled
The network device is not
connected, being used, or is not
active.
connected, being used, or is not
active.
Check network link and
device.
device.
Network down
The network device has a problem.
Check network link and
device.
device.
Network in use
The network device is being used by
another device.
another device.
Reset WAN and try to re-
connect.
connect.
Network not ready
The network device is not ready for
use. (yellow LED)
use. (yellow LED)
Make sure primary connect
matches “enabled” WAN port.
matches “enabled” WAN port.
No bandwidth
The unit bandwidth is
oversubscribed. No network
bandwidth is available for telephone
signaling
oversubscribed. No network
bandwidth is available for telephone
signaling
Change voice compression.
Normal take down
Displayed when the network device
is either being rebooted or reset.
is either being rebooted or reset.
Wait until the WAN link LED
is solid green, and then
attempt to re-connect.
is solid green, and then
attempt to re-connect.
No Voice path
(see note)
(see note)
The unit bandwidth is
oversubscribed. No network
bandwidth is available for voice.
oversubscribed. No network
bandwidth is available for voice.
Change voice compression.
Peer disconnect
Displayed when the Switch unit has
disconnected from the network
device.
disconnected from the network
device.
Check the voice compression
or network at the
PBXgateway.
or network at the
PBXgateway.
Note: This message is not preceded by “Connect error”.