Citel 4100 Guia Da Instalação

Página de 26
IP Single or Dual Port EXTender 4100: Quick Installation Guide 
17
 
3.  Subnet Mask – A valid subnet mask for the Remote must also be entered in 
order for it to operate on the IP network. The subnet mask should be 
obtained from the corporate IT Administrator prior to configuring the Remote. 
4.  Default Router – A valid default router address must be entered to reach IP 
hosts not on this same IP sub-network. The default router should be obtained 
from the corporate IT Administrator prior to configuring the Remote. 
 
Path: Remote->Configuration->IP->LAN->Address 
5.  Telnet – The Remote can be accessed remotely by use of a standard Telnet 
session. By default Telnet is enabled. 
6.  Rlogin – The Remote Management Console can also be accessed through 
the Remote’s Gateway Login feature with Rlogin enabled. The Gateway 
Login feature is found here: Path: Remote->Gateway Login. For security 
reasons this feature is disabled on default. 
7.  FTP – File Transfer Protocol (FTP) is used primarily during the upgrade 
process. For security reasons this feature is disabled on default. FTP should 
remain disabled when not upgrading a unit or unless otherwise instructed to 
by a customer support representative. 
An Administrator’s password should be set to restrict unauthorized access to 
Remote. If the password is lost or forgotten please contact a customer support 
representative at 1-877-248-3587 or 
 for details on how to 
reset the unit’s password. Individual port passwords are not affected. 
T
HE 
E
SSENTIAL 
C
ONFIGURATION 
P
ARAMETERS FOR THE 
R
EMOTE ARE 
N
OW 
C
OMPLETE
.
 
F
OR 
A
DVANCED 
C
ONFIGURATION 
P
ARAMETERS 
R
EFER TO THE 
L
IST ON 
 OR THE 
S
YSTEM 
A
DMINISTRATOR
G
UIDE FOR 
F
ULL 
D
ETAILS
.
 
 
P
LEASE 
T
EST THE 
C
URRENT 
C
ONFIGURATION BY 
M
AKING A 
F
EW 
“T
EST
 
P
HONE 
C
ALLS 
P
RIOR TO 
G
OING ON TO THE 
A
DVANCED 
C
ONFIGURATION 
S
ECTION
Testing the Installation 
If the units are installed properly, but you still cannot connect the remote 
telephone, you should test the IP connection. This test will not run if the 
telephone is off-hook. 
1.  Access the Management Console (MC). 
2.  Reset the IP Port. 
Path: Remote->Utilities->Diagnostics->Test IP 
3.  Using the default values, select “Begin Test.” This test will send voice 
packets to the offsite unit and will count the packets as they are sent back. 
4.  The MC will run the test and, upon completion, a test results window appears 
as shown on the next page: 
 
© Copyright 2007 Citel plc All Rights Reserved