Campbell Hausfeld 20-gallon air compressor Guia Do Utilizador
Contractor Air
Compressors
Compressors
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-
erty damage! Retain instructions for future reference.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-
erty damage! Retain instructions for future reference.
Operating Instructions
IN227906AV 12/02
Air compressor units are intended to
provide compressed air to power pneu-
matic tools and operate spray guns. The
pumps supplied are oil lubricated. A
small amount of oil carryover is present
in the compressed air stream.
Applications requiring air free of oil or
water should have the appropriate coa-
lescing filter installed. The air compres-
sor unit must be placed on a solid floor
or solid ground. Any other use of these
units will void the warranty and the
manufacturer will not be responsible for
problems or damages resulting from
such misuse.
provide compressed air to power pneu-
matic tools and operate spray guns. The
pumps supplied are oil lubricated. A
small amount of oil carryover is present
in the compressed air stream.
Applications requiring air free of oil or
water should have the appropriate coa-
lescing filter installed. The air compres-
sor unit must be placed on a solid floor
or solid ground. Any other use of these
units will void the warranty and the
manufacturer will not be responsible for
problems or damages resulting from
such misuse.
All models are equipped with cast-iron
pumps. Gas engine models are equipped
with an air governor for automatic idle
down when the tanks reach a preset
pressure. Model VT6131 is driven by a
dual capacitor, 3450 RPM, 60 Hz,
120/240 dual-voltage motor with manu-
al reset thermal protection. Honda
engine models have a low-oil level shut-
down.
pumps. Gas engine models are equipped
with an air governor for automatic idle
down when the tanks reach a preset
pressure. Model VT6131 is driven by a
dual capacitor, 3450 RPM, 60 Hz,
120/240 dual-voltage motor with manu-
al reset thermal protection. Honda
engine models have a low-oil level shut-
down.
Compressors include factory-mounted
belt guards, ductile iron crankshafts, fly-
wheels and ball bearings on crankshaft.
belt guards, ductile iron crankshafts, fly-
wheels and ball bearings on crankshaft.
Safety Guidelines
This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROB-
LEMS. To help recognize this informa-
tion, observe the following symbols.
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROB-
LEMS. To help recognize this informa-
tion, observe the following symbols.
Danger indicates
an imminently haz-
an imminently haz-
ardous situation which, if not avoided,
will result in death or serious injury.
will result in death or serious injury.
Warning indicates
a potentially haz-
a potentially haz-
ardous situation which, if not avoided,
could result in death or serious injury.
could result in death or serious injury.
Caution indicates a
potentially haz-
potentially haz-
ardous situation which, if not avoided,
may result in minor or moderate injury.
may result in minor or moderate injury.
!
CAUTION
!
WARNING
!
DANGER
Notice indicates
important informa-
important informa-
tion, that if not followed, may cause
damage to equipment.
damage to equipment.
Unpacking
After unpacking the unit, inspect care-
fully for any damage that may have
occurred during transit. Make sure to
tighten fittings, bolts, etc., before
putting unit into service.
fully for any damage that may have
occurred during transit. Make sure to
tighten fittings, bolts, etc., before
putting unit into service.
Do not operate
unit if damaged
unit if damaged
during shipping, handling or use.
Damage may result in bursting and cause
injury or property damage.
Damage may result in bursting and cause
injury or property damage.
Since the air compressor and other com-
ponents (pump, spray guns, filters, lubri-
cators, hoses, etc.) used make up a high
pressure pumping system, the following
safety precautions must be observed at
all times:
ponents (pump, spray guns, filters, lubri-
cators, hoses, etc.) used make up a high
pressure pumping system, the following
safety precautions must be observed at
all times:
1. Read all manuals includ-
ed with this product care-
fully. Be thoroughly
familiar with the controls
and the proper use of the
equipment.
fully. Be thoroughly
familiar with the controls
and the proper use of the
equipment.
2. Follow all local safety codes as well
as the United States Occupational
Safety and Health Act (OSHA).
Safety and Health Act (OSHA).
3. Only persons well acquainted with
these rules of safe operation should
be allowed to use the compressor.
be allowed to use the compressor.
4. Keep visitors away and NEVER allow
children in the work area.
5. Wear safety glasses and
use hearing protection
when operating the
pump or unit.
when operating the
pump or unit.
6. Do not stand on or use
the pump or unit as a handhold.
7. Before each use, inspect compressed
air system, fuel system and electrical
components for signs of damage,
deterioration, weakness or leakage.
components for signs of damage,
deterioration, weakness or leakage.
!
WARNING
NOTICE
Breathable Air Warning
This compressor/pump is NOT
equipped and should NOT be used
“as is” to supply breathing quality
air. For any application of air for
human consumption, you must fit
the air compressor/pump with suit-
able in-line safety and alarm equip-
ment. This additional equipment is
necessary to properly filter and
purify the air to meet minimal spec-
ifications for Grade D breathing as
described in Compressed Gas
Association Commodity
Specification G 7.1 - 1966, OSHA 29
CFR 1910. 134, and/or Canadian
Standards Associations (CSA).
equipped and should NOT be used
“as is” to supply breathing quality
air. For any application of air for
human consumption, you must fit
the air compressor/pump with suit-
able in-line safety and alarm equip-
ment. This additional equipment is
necessary to properly filter and
purify the air to meet minimal spec-
ifications for Grade D breathing as
described in Compressed Gas
Association Commodity
Specification G 7.1 - 1966, OSHA 29
CFR 1910. 134, and/or Canadian
Standards Associations (CSA).
DISCLAIMER OF WARRANTIES
IN THE EVENT THE COMPRESSOR IS
USED FOR THE PURPOSE OF BREATH-
ING AIR APPLICATION AND PROPER
IN-LINE SAFETY AND ALARM EQUIP-
MENT IS NOT SIMULTANEOUSLY
USED, EXISTING WARRANTIES ARE
VOID, AND CAMPBELL HAUSFELD
DISCLAIMS ANY LIABILITY WHATSO-
EVER FOR ANY LOSS, PERSONAL
INJURY OR DAMAGE.
IN THE EVENT THE COMPRESSOR IS
USED FOR THE PURPOSE OF BREATH-
ING AIR APPLICATION AND PROPER
IN-LINE SAFETY AND ALARM EQUIP-
MENT IS NOT SIMULTANEOUSLY
USED, EXISTING WARRANTIES ARE
VOID, AND CAMPBELL HAUSFELD
DISCLAIMS ANY LIABILITY WHATSO-
EVER FOR ANY LOSS, PERSONAL
INJURY OR DAMAGE.
!
DANGER
Repair or replace defective items
before using.
before using.
8. Check all fasteners at frequent inter-
vals for proper tightness.
Motors, electrical equip-
ment and controls can
cause electrical arcs that
will ignite a flammable gas
or vapor. Never operate or repair in or
near a flammable gas or vapor. Never
store flammable liquids or gases in the
vicinity of the compressor.
ment and controls can
cause electrical arcs that
will ignite a flammable gas
or vapor. Never operate or repair in or
near a flammable gas or vapor. Never
store flammable liquids or gases in the
vicinity of the compressor.
!
WARNING
MANUAL
Description
General Safety
© 2002 Campbell Hausfeld
For parts, product & service information
visit www.chpower.com