Marvel 3swce-bb-g Instrução De Instalação

BOTTOM HINGE CORNER

CAUTION

DOOR CAN BECOME

DISENGAGED IF WASHERS

ARE NOT INSTALLED

TOP HINGE CORNER

SHOULDER BUSHING

.75 OD X .443 ID

.75 OD X .257 ID

SHOULDER BUSHING

WASHER

3 NYLON
HARDWARE

COMPONENTS
AT BOTTOM
HINGE

HARDWARE
COMPONENTS
AT TOP HINGE

2 NYLON

NOT INSTALLED AS SHOWN

COMPONENTS ARE NOT

PROPERLY-IF ALL NYLON

DOOR MAY NOT SWING

.625 OD X .218 ID

WASHER

CAUTION

6. INSTALL THE DOOR TO THE UNIT. USE THE SUPPLIED PLASTIC WASHERS AS SHOWN IN THE FIGURE BELOW.

2. PEEL BACK DOOR GASKET TO EXPOSE THE SCREW HOLES.

3. SET THE WOOD FRAME FLUSH TO THE FRONT OF THE DOOR IN THE DESIRED LOCATION. CLAMP WOOD FRAME TO

THE TOP HINGE. REMOVE THE DOOR BY ANGLING THE DOOR OFF OF THE BOTTOM HINGE PIN.

1. IF THE DOOR IS ATTACHED TO THE UNIT, REMOVE IT BY UNSCREWING THE TOP ALLEN HEAD SET SCREW AT

THE DOOR IF NECESSARY.

4. INSERT THE WOOD SCREWS THROUGH THE BACK OF THE DOOR INTO THE PILOT HOLES IN THE WOOD FRAME AND

5. REINSTALL DOOR GASKET BY PRESSING INTO DOOR CHANNEL. MAKE CERTAIN THE CORNERS ARE INSERTED FULLY.

7. REALIGNING THE DOOR MAY BE NECESSARY. ANY FINAL DOOR ADJUSTMENTS CAN BE MADE USING A 1/8 INCH ALLEN

8. ATTACH THE DOOR LIGHT STRIKER PLATE AS SHOWN USING THE HEX OR PHILLIPS HEAD SCREWS PROVIDED. MAKE

TIGHTEN.

HEAD DRIVER TO ADJUST THE DOOR'S HINGES (SEE FIGURE BELOW).

CERTAIN THE LIGHT IS ABLE TO TURN ON AND OFF WHEN THE DOOR IS OPENED AND CLOSED.

9. ATTACH THE DOOR TO THE UNIT BY REVERSING STEP NUMBER 1 ABOVE.

CAUTION

DOOR CAN BECOME

DISENGAGED IF WASHERS

ARE NOT INSTALLED

CABINET HINGE

WOOD

FRAME

WOOD

FRAME

DOOR HINGE

HINGE HARDWARE

INSTALLATION DETAILS.