Marvel 60rgd-ss-f Guia De Iniciação
FOR MODELS 60RDE and 80RDE WITH OVERLAY PANELS
INSTALLATION INSTRUCTIONS
Determine Wood Screw Requirements
A #8 pan head wood screw should be used to prop-
1.
erly secure the overlay panel. A total of 8 screws per
drawer for the 60 unit and 10 screws per drawer for
the 80 unit will be required.(See Figure 9). Necessary
screws are supplied with unit.
Use only pan head screws.
drawer for the 60 unit and 10 screws per drawer for
the 80 unit will be required.(See Figure 9). Necessary
screws are supplied with unit.
Use only pan head screws.
2.
If your overlay panel is thinner than 5/8” (15.9 mm)
3.
you will need to purchase shorter screws.
Step 1: Remove Drawers from unit.
Remove drawer from the unit. Begin by pulling out the
1.
drawer. Locate the drawer lock which can be found
on the outside of the cabinet slide (see Figure 5). Push
the back of the drawer lock forward and then down,
releasing the drawer from the cabinet slide (see Figure
6). Repeat this on the opposite side of the drawer. Lift
the drawer up from the slides at a 90 degree angle to
fully extricate the drawer from the cabinet (See Figure
7).
Remove the gasket from the drawer front. Do this by
on the outside of the cabinet slide (see Figure 5). Push
the back of the drawer lock forward and then down,
releasing the drawer from the cabinet slide (see Figure
6). Repeat this on the opposite side of the drawer. Lift
the drawer up from the slides at a 90 degree angle to
fully extricate the drawer from the cabinet (See Figure
7).
Remove the gasket from the drawer front. Do this by
2.
pulling the gasket out of the channel that holds it to the
drawer front. This will expose the clearance holes for
mounting the overlay panel. (See Figure 8).
drawer front. This will expose the clearance holes for
mounting the overlay panel. (See Figure 8).
Figure 6
Figure 7
Figure 5
10
Figure 9
.35/.31
(9mm/7.5mm)
.50
(12.5)
Gasket
Figure 8