Marvel 60rgd-ss-f Guia De Iniciação
INSTALLING THE ANTI-TIP DEVICE
4
A cabinet “anti–tip” device is mounted to the back of your
refrigerated drawer unit. If your installation is a built – in
undercounter application with a countertop directly above
the unit this item can be removed, it does not need to be
applied. If your unit is a freestanding application with no
countertop directly above the top of the unit, you must
apply this feature to prevent the unit from tipping forward
when the drawers are pulled out. The anti–tip device
is installed on the back of the unit. The anti–tip device
reduces the chance of personal injury as well as property
damage when properly installed between the back of
the unit and the adjacent wall. Please see the following
instructions for installing the anti-tip device.
refrigerated drawer unit. If your installation is a built – in
undercounter application with a countertop directly above
the unit this item can be removed, it does not need to be
applied. If your unit is a freestanding application with no
countertop directly above the top of the unit, you must
apply this feature to prevent the unit from tipping forward
when the drawers are pulled out. The anti–tip device
is installed on the back of the unit. The anti–tip device
reduces the chance of personal injury as well as property
damage when properly installed between the back of
the unit and the adjacent wall. Please see the following
instructions for installing the anti-tip device.
1. Push the unit against the wall so the anti-tip
bracket is flush to the wall adjacent to the back
panel. Level the unit with the leveling legs provided
in the cabinet bottom. (See Leveling Legs on
page 3).
2. Using a pencil and the bracket as a template, trace
the bracket on the wall, making sure 2 of the screw
holes are aligned with a stud in the wall.
3. Pull the unit away from the wall.
4. Remove the screws that connect the upper and
lower sections of the anti-tip bracket.
5. Place the bracket on the wall and mark and drill
3/16” dia. Pilot holes for the provided ¼” lag
screws. Mount the lower section to the wall with the
¼” lag screws.
6. Move the unit into place aligning the screw holes
between the upper and lower brackets and secure
with the screws removed in step 4.
bracket is flush to the wall adjacent to the back
panel. Level the unit with the leveling legs provided
in the cabinet bottom. (See Leveling Legs on
page 3).
2. Using a pencil and the bracket as a template, trace
the bracket on the wall, making sure 2 of the screw
holes are aligned with a stud in the wall.
3. Pull the unit away from the wall.
4. Remove the screws that connect the upper and
lower sections of the anti-tip bracket.
5. Place the bracket on the wall and mark and drill
3/16” dia. Pilot holes for the provided ¼” lag
screws. Mount the lower section to the wall with the
¼” lag screws.
6. Move the unit into place aligning the screw holes
between the upper and lower brackets and secure
with the screws removed in step 4.
Anti - Tip Device
Anti-Tip device
Figure 3
To Wall
To Refrigerated
Drawer Cabinet
Drawer Cabinet
Remove these screws to seperate
upper and lower sections of anti-tip
bracket.
upper and lower sections of anti-tip
bracket.
Figure 4
1/4” Lag screws
into wall
into wall