Marvel 6obarmssfr Guia Do Utilizador

Página de 24
14
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Model
W
H
3BARM
14-5/16”
(36.35cm)
30-5/16”
(76.99cm)
6BARM
23-7/16”
(59.54cm)
30-5/16”
(76.99cm)
Table B
W
H
Front of
overlay
panel
Figure 6
1-23/32”
(38.77cm)
Typical 4
Sides
Step 5: Clamp panel to door
Set the overlay panel on the door front, align the edges, 
and clamp together. Clamp the panel firmly but be care-
ful not to crush the foam in the door or scratch the door.
Step 6: Drill holes in overlay panel
Remove the hinge adapter bushings from the top and 
bottom door hinge adapters. (See Figure 10).Using the 
holes in the hinge adapters drill 5/16” (8mm) diameter 
clearance holes into the overlay panels 3/4” (20mm) 
deep. These will be clearance holes for the top and bot-
tom hinge pins.
Also at this time drill the screw pilot holes for attach-
ing the overlay panel to the door. Select the size of the 
hole from Table C. Be careful not to drill the pilot holes 
through the overlay panel but only 1/2” (12.7)mm deep.
Material Type
#8 Wood Screw 
Hardwood
3/32” (2.4mm) Diameter. Pilot Hole
Softwood
5/64 (2.0mm) Diameter. Pilot Hole
Table C
If your refrigerator has a door lock proceed to Step 7. 
If your refrigerator does not have a door lock proceed 
to Step 9.
NOTE
NOTE
Step 7: Mark and drill lock hole.
Locate and mark with a pencil the location of the lock 
hole on the overlay panel, this is the hole  in the top 
corner of the handle side of the door. Remove the clamp 
and remove the overlay panel from the door. On the 
backside of the panel where you marked the lock location 
drill a 13/16” (20.5mm) diameter counter bore 7/16” 
(11.0mm) deep into the overlay panel. Drill a 15/32” 
(12.0mm) diameter hole through the overlay panel cen-
tered on the counterbore being careful not to splinter the 
wood on the face side of the panel. (See Figure 7).
Step 8: Assemble the lock parts
Two (2) lock extensions are supplied with the lock. Use 
the longer extension for a 3/4” thick overlay panel and 
the shorter one for a 5/8” thick panel. Assemble the lock 
extension, cam stop washer, spring washer, and set screw  
to the lock as shown in Figure 7 and 8. 
Install this assembly into the overlay panel and secure 
with the retaining nut using a 15mm socket. Make sure 
the key slot in the lock is vertical.
Figure 7
SECTION A-A 
SCALE 1 : 1
LOCK
NUT
BRASS EXTENSION
CAM
PHILLIPS SCREW
13/16 COUNTER
BORE 7/16 DEEP
15/32 HOLE
3/4 INCH
WOOD PANEL
SPRING WASHER
INNER
DOOR
Glass Door Models
Glass Door Models