Revel ic65 Instrução De Instalação

Harman Specialty Group

3 Oak Park Drive

Bedford, MA  01730-1413

USA

Tel 781-280-0300

Fax 781-280-0490

www.revelspeakers.com

Customer Service

Tel 781-280-0300

Fax 781-280-0495 (Sales)

Fax 781-280-0499 (Service)

Revel Part No. 170-0095 |  Rev 0 |  02/07

Step 1: Snap the two flat
wing sections onto the frame
as shown.

Step 2: Position the Rough-In Bracket/Wing assembly
between the wall studs so that the bracket is in the correct
position for the final speaker placement. Nail the assembly
into place, making sure that the nail heads are as flush
against the wings as possible.

Note: 
Make sure that the wire tabs on the assembly are in the
back, so they are on the inside of the wall.

Step 3: Use the wire tabs to hold pre-routed speaker wires in
place. Ensure that no wire remains exposed on the front (wall
board) side of the assembly. 

Step 4: After the wall board is installed, cut out the hole for the speaker using the inside cut-out of the
frame as a guide. The speaker wire can then be run through the opening in the wall board and attached to
the speaker system - refer to the Owner’s Manual of the loudspeaker for more information on system
setup.